G99
13685
nice condition piece.
Omega still have bezels as far as i'm aware as i see them advertised on 'the big auction site' ocassionally so if you send it to them you should be able to get them to put one on. you wont get an aftermarket bezel for this fairly uncommon piece (relative to the later speedmasters).
if i were you i would search the internet site to see what comes up.
i'm not sure about the dial and chrono hands, the white font seems just too good and the hands should be steel not white, but these are only minor points. even if the dial has been refinished the lumed indices look original which i consider the most important.if its been to Omega for servicing in the past they are experts in replacing dials and hands when you dont want them to.
hope this helps a bit and good luck with your search.
Graham
nice condition piece.
By: G99 : September 1st, 2010-02:00
Omega still have bezels as far as i'm aware as i see them advertised on 'the big auction site' ocassionally so if you send it to them you should be able to get them to put one on. you wont get an aftermarket bezel for this fairly uncommon piece (relative ...
Omega Dial
By: WatchCrazy : September 3rd, 2010-08:39
Thanks bill for the info. After looking closely to the dial, The surface of the dial and the outer ring is the same except for the slight color difference. And actaully there is no step on it. The color variation can kind of distort your eyes. I am most c...
great watch!
By: Gunnar : October 4th, 2010-09:29
Hello, The dial is beautiful and 100% correct for the CK2915-2. Unfortunately the Pic from Bills CK 2915 shows very little of the features of an original CK 2915 The dial is from an early CK2998. You can see that in the minute totalisator. Every 5 minutes...
2915 bezel
By: WatchCrazy : July 28th, 2011-09:28
An Ebayer in Australia is selling the bezel for 2915 and 2998. The bezel really looks great and original. Do you guys think that it will fit my 2915. The measurement stated in the auction is 40mm outer and 34mm inside diameter. Very tempting to try gettin...