Hi Nino, this is a...

Hi Nino, this is a very good point – thank you. I will follow up and let you know what the measurement shows.

By the way, I found the e-mail from Breguet service manager where he explained what they found when I sent the watch for repairs. His response reads:

"Please kindly note that your Marine watch's movement does not present any mechanical defect and none of its components is defective. However, a few points of oil have prematurely dried on some components and caused the watch to run ahead, a problem we have fixed by revising the movement (cleaning of its components and new lubrication of components needing oil)."

I am not a specialist, but I would expect that in a hermetically sealed watch the lubricant should not be drying up, but then again, I am not a specialist.

So, on your advise I am going to take the watch to a local watchmaker for measuring its frequency and report back his findings.

Best regards

Slava S.

💰169 Marketplace Listings for Breguet›

Breguet 5817 slow

By: Slava S. : April 1st, 2012-15:33

I have had this watch for three years now. Initially it kept very good time - plus or minus about 30 sec a month. Two years ago it stated to fall behind - about 1 minute a week. I sent it to Breguet for repair. It took them three month, but when the watch...

You do seem to be within the acceptable range.

By: Bill : April 1st, 2012-16:30

I came across this chart some time back on the internet not sure who to credit. It gives you a range for reasonable expectations. It seems you are falling in the middle of Modern mechanical watch non-certified at -5 per day. But it seems strange that afte...

Is there a published spec for the watch?

By: Slava S. : April 1st, 2012-20:33

Bill, thank you for the response. The table is interesting, but I am wondering how it relates to this specific watch. Do you know whether Breguet ever published a specification for the watch? I found a description on this site http://www.presentwatch.com/...

The example I provided was a guide

By: Bill : April 2nd, 2012-06:41

It was merely to represent the fact that mechanical watches have margins in which the operate. But I do think you should try and find out why you get such a variance after each service which seem not to be normal. Bill

Bill, thank you for the...

By: Slava S. : April 2nd, 2012-10:13

Bill, thank you for the infromation and encouragememt - very much appreciated. Best regards Slava S.

It is a great watch for sure

By: Bill : April 2nd, 2012-16:10

Breguet Marine 5817...

... In its proper environment. Cool to see that this watch has such a great life. [nt]

By: amanico : April 2nd, 2012-20:31

No message body

If you have access ...

By: nilomis : April 2nd, 2012-12:04

To a watchmaker that has a good timing machine (the moderns Witsch are great) I would suggest that you do a quick check. There you can remove the potential ambiguity and check if your watch is under the correct parameters on all positions. I do this check...

Hi Nino, this is a...

By: Slava S. : April 2nd, 2012-19:53

Hi Nino, this is a very good point – thank you. I will follow up and let you know what the measurement shows. By the way, I found the e-mail from Breguet service manager where he explained what they found when I sent the watch for repairs. His respo...