ekintay
101
issue with 3126 movement
i owned a ROO Panda G series. less than 2 years later, the power reserve is low, went back to service centre and it was resolve as it was under warranty. then 4 months ago, the watch stop completely and the second hand doesn't move at all even after winding it.
so send back and the service centre told me the movement is dirty and need complete overhaul.....cost me slightly less than 2k and warranty over.
my younger brother also owned a ROO Safari H series and it also went to service centre twice, lucky for him, it is under warranty. same issue.....power reserve as well as movement jammed.
now i stop wearing the watch and i dun even put them in watch winder.
Andrew
Singapore
Power reserve Issue
I just bought a RG 44MM Royal Oak offshore and the watch does not hold any power. i.e stops after two hours off the wrist , even though I have been wearing it and fairly active all day. Anyone else have this issue or heard of it.? Will take it to service ...
Not normal but-
I also have a similar issue with a 44mm ROO which is only a couple of months old. Power reserve totally gone within under 20 hrs and looses a minute every hour. Also spoken to another guy with the same problem as you, no power after an hour, just stops de...
issue with 3126 movement
i owned a ROO Panda G series. less than 2 years later, the power reserve is low, went back to service centre and it was resolve as it was under warranty. then 4 months ago, the watch stop completely and the second hand doesn't move at all even after windi...
Mvt Dirty?
I wonder how the mvt could get dirty inside the case? If the lubricants had dried out maybe? That's a strange one.
yes sir.
that is exactly what the service centre wrote on the piece of paper and e-mail me. i still have the e-mail. it says: our watchmaker found the following causes 1.M.M.13 complete service required MVT DIRTY