From_sketch_to_watch
12
Details
Hi, all pictures show parts directly after milling, first picture is the crown wheel, second picture show some hairspring stud plates, third picture the ratched wheel and the fourth picture the balance wheel bridge. All of them are cutted directly into a bar of AP20 steel using some delicate endmill down to 0.25mm.
After milling they have to be turned on the lathe to the right height after that they will be tempered and finished by hand this will be take a few hours up to days per each part.
Watch project update October 2017
Good evening everybody! In October I spent a lot of time to produce a lot of steel parts like bridges, ratchet wheels, crown wheels and springs and there are still some steel parts needed, once they are all made i have to temper and finish them. It was al...
Thank you very much for this update. I’m sure many of us are really interested in your project and progress reports
Please can you tell us more about these four shots? Best wishes Alkiro
Details
Hi, all pictures show parts directly after milling, first picture is the crown wheel, second picture show some hairspring stud plates, third picture the ratched wheel and the fourth picture the balance wheel bridge. All of them are cutted directly into a ...
