cazalea[Seiko Moderator]
16932
That’s not unusual
Feb 11, 2020,04:50 AM
If you hold the watch level, dial up, and twist it side to side, clockwise then counterclockwise you are encouraging the balance wheel to start oscillating.
I have several watches that exhibit such behavior. None Of them are VC
Cazalea
Comments:
view entire thread
Question for Caliber 4400 owners
By: icecube4000 : February 10th, 2020-11:31
Hi, I bought a VC 1921 last week. When I wind the watch, the seconds hand doesn’t start moving until I turn the watch to look at caseback OR take out and push the crown back. It doesn’t matter how many winding turns I have done on the crown, it seems as i...
Sounds unusual
By: walidk : February 10th, 2020-19:03
First of, a hearty congratulations on a beautiful piece! I have had a cal 4400 in the traditionelle (82172) for some 8+ years but never seen this issue. My first guess would be something to do with the crown/winding stem. Since its a recent purchase, it m...
Just checked
By: Jurry : February 11th, 2020-03:44
Just did a check on the two pieces we have. The large one: After approx 15-20 turns the second hand started running but I did slip my hand a bit After about 75 turns I could feel the resistance increasing and that’s where I usually stop winding it (I beli...
That’s not unusual
By: cazalea : February 11th, 2020-04:50
If you hold the watch level, dial up, and twist it side to side, clockwise then counterclockwise you are encouraging the balance wheel to start oscillating. I have several watches that exhibit such behavior. None Of them are VC Cazalea
That’s right
By: cazalea : February 11th, 2020-21:19
Not all watches, but some of them. A little “stiction” or friction in the bearings can be the reason. Cazalea