toxly347
594
Are the holes in the lugs also angled with the trajectory of the curved pin?
Jun 21, 2022,12:33 PM
I have been tempted to get curved pins and a curved thick strap for a Geophysic, which has a gap between the case and the strap even at the centre of the case, but so far remained cautious.
Comments:
view entire thread
1921 with straight spring bar?
By: Ping.Timeout : June 21st, 2022-09:29
Hey folks. Finally i have found straps i wanted to purchase, however they come only in straight spring bar. I understand that the 1921 uses slightly curved bar. Any idea if strap with straight bar would fit? I have the 36.5mm version. ...
Order some curved spring bars …
By: Cpt Scarlet : June 21st, 2022-10:10
personally would only fit the original specification spring bars. They were specified for a reason.
Yes…
By: Cpt Scarlet : June 21st, 2022-11:08
But it depends on the thickness and texture of the strap.
Thanks
By: toxly347 : June 21st, 2022-13:44
I think it is best to continue to use as intended by the manufacturer.
Yep
By: Ping.Timeout : June 21st, 2022-15:15
This is true
By: Ping.Timeout : June 21st, 2022-13:46
I was curious to i checked the VC and JLC holes, they are similar in terms of angle. Others may be different.
👍
By: Ping.Timeout : June 21st, 2022-22:38
Cheers !
By: Ping.Timeout : June 21st, 2022-22:33
Thanks!
By: TeutonicCarFan : June 21st, 2022-18:04
I have the other tools, not the black one. What is the name of it? It seems very helpful. I hate the metal Bergeron on my iwc or vc where the strap is very thick/ low compliance. I also have horotech screwdriver makes link removal easy! I also don't get w...