LS
1009
Just checked my Speedy Pro.
Nov 26, 2020,19:28 PM
Bottom one seems to stick out farther...
Have owned it for eight years and it is probably overdue for a service.. I think on average the top pusher is used twice as often as the bottom. So perhaps the top spring has softened a bit and it doesn't push the pusher cap out as far?
Not really a big deal as far as I’m concerned though.
Comments:
view entire thread
Omega SM gap between pusher and case
By: amg786w : November 26th, 2020-05:51
Hi all, Hope everyone is doing well. I thought it was just me and my Speedie, but when I look at many other SM on the net, I notice that the gap between the chrono pusher (@ 4 o’clock) and the case is wider than the one at 2 o’clock. Is there a reason for...
It could be the "angle" at which the pictures are taken,
By: K-Lo : November 26th, 2020-07:02
Sometimes I notice "something" seems to be off on an object, space-wise, measurement-wise, but that is only because I am looking at it from a certain angle. However, when looking at said object from the right angle, all spaces and/or measurements are corr...
Not the case with my
By: myles721 : November 26th, 2020-08:50
DSOTM black black...I really like the Pitch Black though...but the next one might be Grey side.
Second hand sweep
By: Weems@8 : November 26th, 2020-11:13
I have the habit to see speed variations in the motion of the second hand. When measure a watch, it is ok. I lay my watches on different angles to keep it easy for a movement. I red Louis Breguet invented the tourbillon to get rid off the problem with gra...
Just checked my Speedy Pro.
By: LS : November 26th, 2020-19:28
Bottom one seems to stick out farther... Have owned it for eight years and it is probably overdue for a service.. I think on average the top pusher is used twice as often as the bottom. So perhaps the top spring has softened a bit and it doesn't push the ...
Pusher
By: puutarhakaapio : November 26th, 2020-21:40
...or then the screw inside the pusher is getting loose (pusher turns) and then one day you will see no pusher ! It is quite common problem. Qualified watchmaker would be able to find the right answer to your question. Have a nice day.