
When I check the watch a little closer it was not time yet for a cleanup. So until the time you get to be satisfied with last year's cleanup. Cleaning Time My good old beater need som cleaning I guess. So I start to pull off the bracelet. And I found some dirt. No serial, is it a fake? I have to cle
Cleaning Time
My good old beater need som cleaning I guess.
So I start to pull off the bracelet.
And I found some dirt.
No serial, is it a fake?
I have to clean it up a bit before open it.
So I pull out my case opener.
Lets open it.
The movement looks ok, the Oyster case have keep it clean.
So I start with the crown.
Next step is to release the movement.
And pull it out.
Then I have to pull off the bezel.
And the crystal too.
Now all parts are separated.
So now into the ultrasonic cleaner.
I set it to 9 minutes.
One minute later I can't see the parts.
I know you don't need this pic but I couldn't resist.
No I have to rinse the parts in clean water.
And they looks great.
So I start to put the movement back.
And try to find some spare parts.
A new crystal and a backcase gasket.
This will be nice.
Back with the bezel.
Checking how it runs, a little low amplitude but it's ok for a beater..
And then the backcase.
Checking so it's waterproof.
And now fit to serve me for another year.
Very interesting the way you have put this story together. Thank you.
any thought to getting a new bezel? Or you like it especially like that? Thanks for tthis post!!! S
watch and amazing 'workshop'! Thanks for the post.
This thread is active on the Horological Meandering forum with 6 replies. Share your knowledge with fellow collectors.
Join the Discussion →